Where is the VIN number in Ford Mondeo (Mondeo II [2001-2006])?

This guide shows where to find the VIN (chassis number) on the Ford Mondeo II, produced between 2001 and 2006—including the most reliable stamped location and the easiest-to-read label.

Chassis Number Locations

Engine Bay Bulkhead / Firewall (Stamped Chassis Number)

• Where to look: Open the hood and go to the engine compartment firewall (bulkhead). Locate the vertical metal lip directly behind the engine block, then lift the rubber weatherstrip seal—the VIN is stamped into the metal slightly off-center.
• Access: Expect poor lighting (shadowed by the hood/scuttle) and possible grime/corrosion. You may need to wipe, scrub lightly, or use brake cleaner on a rag to reveal the characters.
• Note: The reference video is filmed on an RHD car, where the stamping appears on the vehicle’s left side. On LHD Mondeo models, check the same physical area (it may appear closer to your driver-side side of the bay).
• Tip: If the stamping is dark or rust-stained, use High Contrast AI Mode and scan it instead of guessing letters—try to scan the stamped VIN directly with your phone after wiping the metal clean.

Engine Bay Scuttle/Cowl Viewing Window (VIN Label Under Plastic Trim)

• Where to look: At the base of the windshield, find the black plastic scuttle panel (near the wipers). Look for a small rectangular clear window/cutout—a white VIN label is visible through it.
• Access: This is usually easier than the stamping, but the plastic window can get cloudy/scratched, and sky glare can wash out the text.
• Note: Works the same on LHD and RHD cars; just approach it from the outside at the windshield base.
• Tip: To beat reflections, change your viewing angle and capture the VIN instantly with the VIN scanner so you don’t mistype characters through glare.

Lower Windshield / Dashboard VIN (Typical Location)

• Where to look: Check the bottom corner of the windshield on the passenger side (viewed from outside the car). The VIN is typically displayed on a dashboard plate readable through the glass.
• Access: No tools—just clean the glass if needed.
• Note: If it’s not visible, rely on the engine bay stamping and scuttle window label above.
• Tip: Windshield VINs are prone to reflections—use your phone to scan it cleanly without transcription errors from a slight angle.

Video Guide

Video Tutorial: Ford Mondeo (2005) Chassis Vin Number Location

▶ Watch Ford Mondeo VIN Location Guide

• A quick under-hood walkthrough showing the stamped bulkhead VIN and the scuttle-panel viewing window with the VIN label.

Common Problems & Troubleshooting

• Rust/grime on the firewall stamping: Scrub lightly and wipe the surface before reading; corrosion can hide characters like B/8 or S/5.
• Shadows under the hood: The bulkhead area sits deep behind the engine—use a bright light and take a close, steady photo for zooming.
• Sticker vs. stamping mismatch: Labels can be replaced; for verification, the stamped bulkhead VIN is usually the most trusted identifier.

---