Where is the VIN number in FORD Kuga (Kuga III [2020-2022])?

This guide shows the VIN number locations for the FORD Kuga III (2020–2022), including the hidden chassis stamp and the quick-check windshield VIN.

Chassis Number Locations

Right-hand rear footwell floor panel (chassis VIN stamp)

• Where to look: Open the rear right door and look on the rear right passenger footwell floor. You’ll see a rectangular plastic trim flap labeled “VIN” set into the carpet—lift/unclip that flap and the VIN is stamped into the metal cross-member underneath.
• Access: Expect low light under the front seat shadow. Kneel at the rear door and pry/lift the flap carefully (it can be stiff if dirty). If the stamp is dusty, wipe it before reading.
• Note: The stamp is on the right-hand side of the vehicle (vehicle-right as you sit facing forward). On LHD cars this is commonly the front passenger-side area when reaching under the seat from the rear, but if you don’t find it there, check the opposite footwell area as layouts can vary by market.
• Tip: Because it’s dark and you’ll be holding the phone at a steep angle, use the flashlight and let OCR do the work—scan the VIN directly with your phone instead of trying to write it down in that awkward position.

Windshield VIN plate (dashboard)

• Where to look: From outside the car, look through the windshield at the lower corner of the dashboard on the passenger side (standard VIN plate position).
• Access: Easy to reach, but reflections/glare from sunlight can wash out the small characters.
• Note: This is the quickest check, but it should match the stamped chassis VIN.
• Tip: If glare is bouncing off the glass, move your phone closer and capture it instantly—use the VIN scanner to avoid transcription mistakes when the tag is hard to read.

Video Guide

Video Tutorial: Ford Kuga (2021) Chassis Vin Number Location

▶ Watch FORD Kuga VIN Location Guide

• Shows the rear right footwell “VIN” flap being lifted to reveal the chassis stamp, then briefly shows the windshield VIN.

Common Problems & Troubleshooting

• Too dark under the seat / bad viewing angle: Use a flashlight and shoot from directly above the stamp; re-try after wiping dust off the stamped groove.
• Low contrast stamp (painted metal): Clean the area and change the angle of the light so the characters cast a shadow (side lighting helps).
• Windshield plate vs. chassis stamp mismatch: Don’t rely on a sticker/visible plate alone—always confirm the stamped chassis VIN matches the registration/title before buying.

---