Where is the VIN in the Hyundai Tucson?

This guide shows you where to find the VIN on the Hyundai Tucson IV (NX4) produced between 2021-2021, including the quickest “walk-up” windshield check and the more reliable stamped chassis VIN.

Chassis Number Locations

Floor (Chassis Stamped VIN)

• Where to look: Lift the carpet flap under the front right seat. The VIN is stamped directly into the chassis cross-member (metal stamping under a pre-cut carpet opening).
• Access: Low difficulty, but you must interact with the interior trim. Slide the seat all the way back, then lift/pry the carpet flap (often held by Velcro or a plastic tab). Expect poor lighting under the seat.
• Note: On many LHD vehicles this ends up being commonly on the passenger side, but it’s still on the right side of the vehicle—if you don’t find it there, check the opposite front seat area as well.
• Tip: Because it’s dark and the stamped characters can be low-contrast, use your phone light and scan it directly with the flashlight + OCR VIN reader instead of trying to guess letters/numbers.

Windshield VIN (Dashboard Plate)

• Where to look: Look through the lower corner of the windshield at the VIN plate on the dashboard (side varies by market, but it will be at the bottom corner).
• Access: Very easy—viewable from outside the car—however reflections and glare can make it hard to read.
• Note: For LHD vehicles, the windshield VIN is commonly easier to check from the curb side; for RHD it may appear on the opposite lower corner.
• Tip: If glare is washing out the characters, capture it with your phone using the VIN scanner so you don’t mistype similar characters like 8/B or 5/S.

Certification Label (B-Pillar / Door Jamb)

• Where to look: Open the front door and inspect the B-pillar door jamb area for the black certification label (typically includes VIN and sometimes paint code).
• Access: Easy—no tools—just open the door and read the label.
• Note: Depending on market, the label may be on the driver’s side or passenger side door jamb.
• Tip: If the label print is small or you’re reading it at an angle, use the free VIN reader to scan it cleanly rather than copying it by hand.

Video Guide

Video Tutorial: Hyundai Tucson (2021) Chassis Vin Number Location

▶ Watch Hyundai Tucson VIN Location Guide

• Short, clear walkthrough showing how to access the stamped chassis/VIN under the front seat by lifting the carpet flap.

Common Problems & Troubleshooting

• Can’t see the stamped VIN under the seat: Slide the seat fully back, then aim a flashlight straight down—under-seat areas are shadowy and the stamping can be body-color/low contrast.
• Carpet flap won’t lift easily: Feel for Velcro or a retaining tab, then pry/lift gently; don’t yank because you can tear the carpet edge.
• Sticker/label looks tampered or missing: Door-jamb labels can be replaced—always cross-check the windshield VIN + stamped floor VIN for a proper match.

---

This guide shows where to find the VIN (Vehicle Identification Number) on the Hyundai Tucson III, produced between 2016 and 2020, using the same spots you’ll need for registration checks, parts matching, and verifying the car’s identity.

Chassis Number Locations

1) Floor VIN (under the front seat, under flap)

• Where to look: Check the front footwell floor on the floor cross-member under the front seat. There’s a pre-cut plastic/carpet flap—lift it to reveal the VIN stamped into the chassis metal.
• Access: Slide the front seat all the way back to create space, then pry/lift the flap. Expect poor lighting and shadows, especially if floor mats cover the flap.
• Note: This stamped VIN sits on the right-hand side of the vehicle (direction of travel). On LHD Tucson it’s commonly under the passenger seat; on RHD models it can be under the driver seat—same physical side, different seat “role”.
• Tip: Because it’s dark and you’re working low in the footwell, use ScanVin.app to turn on flashlight and scan the stamped VIN with OCR instead of trying to read it at an awkward angle.

2) Windshield VIN plate (dashboard, behind glass)

• Where to look: Look through the windshield at the lower corner, where the VIN plate sits behind the glass on top of the dashboard (visible from outside).
• Access: No tools required, but you may need to change your viewing angle to beat reflections; dirty glass can hide characters.
• Note: In the videos, the plate appears to remain on the left side of the dashboard across markets (even when steering wheel position changes).
• Tip: If glare/reflections make the digits hard to confirm, capture it instantly with ScanVin.app to reduce transcription mistakes.

3) B-pillar / door jamb VIN label (ID sticker)

• Where to look: Open the front door and inspect the B-pillar door jamb for a black sticker with white text that lists the VIN plus paint/trim details.
• Access: Usually easy—just open the door and hold the camera steady. Labels can fade/peel with age, and the vertical sticker orientation can blur if your hand moves.
• Note: The main ID label is shown on the left B-pillar in both LHD and RHD examples. Don’t confuse it with other nearby stickers (e.g., tire pressure or compliance plates).
• Tip: For a fast, high-accuracy read on the high-contrast sticker, use the free VIN reader on ScanVin.app and scan instead of manually typing the characters.

Video Guide

Video Tutorial: Where to find VIN number on Hyundai Tucson III (2015–2020)

▶ Watch Hyundai Tucson VIN Location Guide

• Concise LHD walkthrough showing the floor stamped VIN (under flap), windshield VIN plate, and the B-pillar label.

Video Tutorial: Where is the VIN number of my Hyundai Tucson III ( 2015 - YouTube

▶ Watch Hyundai Tucson VIN Location Guide

• Detailed RHD walkthrough showing windshield VIN, B-pillar ID label, and the floor stamped VIN under the front seat—useful for UK/AU/Japan-market cars.

Common Problems & Troubleshooting

• Can’t find the stamped VIN under the seat: Slide the seat fully back and check for a pre-cut flap hidden under mats; use a flashlight because shadows are common in the footwell.
• Windshield VIN is hard to read: Glare/reflections and dirty glass can obscure characters—shade the area with your hand and clean the glass for a clear view.
• Sticker VIN doesn’t look “official”: Door-jamb labels can fade, peel, or be replaced—always cross-check the sticker VIN against the stamped floor VIN and vehicle documents.

---

This guide shows the real-world VIN (Vehicle Identification Number) locations on the Hyundai Tucson II, produced between 2010 and 2015, including the easiest sticker locations and the stamped “chassis” VIN hidden under the interior carpet.

Chassis Number Locations

1) Driver’s side door jamb (B-pillar label)

• Where to look: Open the driver’s door and look on the driver’s side B-pillar/door jamb. You’re looking for a black or silver manufacturer certification label stuck to the painted metal, usually below the door latch striker.
• Access: Usually the easiest place to check—good light with the door open. The main issue is age damage: the sticker can fade, peel, or get torn.
• Note: Works the same on LHD vehicles (as shown in the reference vehicle context).
• Tip: If the sticker text is light or worn, capture it cleanly in one shot—use the camera to scan the VIN directly with ScanVin.app instead of guessing characters like 8/B/0.

2) Windshield (dashboard VIN plate)

• Where to look: Stand outside the vehicle and look through the lower driver-side corner of the windshield, near the A-pillar. The VIN is on a metal plate riveted to the dashboard.
• Access: Easy to find, but glare/reflections and the windshield angle can make it hard to read or photograph—especially in direct sun.
• Note: Typical Hyundai placement; best viewed from outside with the wheel straight and the dash cleared.
• Tip: Block sunlight with your body or shoot from an angle, then capture the VIN instantly with your phone to avoid transcription errors caused by glare.

3) Floor stamp (under front seat, under carpet flap)

• Where to look: Check the front footwell floor area under the front seat (commonly on the passenger side for LHD vehicles, but check the driver side footwell if not found). Slide the seat all the way back, then lift the pre-cut carpet flap to expose the stamped VIN on the floor cross-member.
• Access: Physically awkward and usually dark. The carpet flap can be stiff or packed with debris. The stamped characters are often low-contrast (same color metal), so they don’t “pop”.
• Note: In the provided context/videos, this floor VIN is shown under the passenger seat for LHD.
• Tip: Turn on your phone light and don’t fight the cramped angle—use ScanVin.app’s flashlight + OCR scanning so you don’t have to write it down while bent over the seat rails.

4) Engine block stamp (engine number area)

• Where to look: In the engine bay, locate the engine block and look for a flat machined surface stamped with the number, facing toward the radiator side. It sits deep in the bay, partially hidden under hoses/cables.
• Access: Very difficult: dark, dirty/greasy, and the viewing angle is steep. Often needs wiping/scrubbing to read.
• Note: This is not the easiest “buyer check” VIN spot—use it as a verification point if other VINs look suspicious or are missing.
• Tip: If grime is hiding the characters, wipe the surface and use High Contrast AI Mode via ScanVin.app to pull faint stampings out of the shadows.

5) Firewall / rear engine bay stamp (secondary, if exposed)

• Where to look: At the top of the firewall near the cowl (rear of the engine bay, under the windshield line). If present and exposed, it’s stamped directly into the metal.
• Access: Often blocked by plastic trim, weather stripping, sound insulation, or dirt—so it can be hard to confirm quickly.
• Note: This area is more of a “secondary check” spot; prioritize the door label and floor stamp first.
• Tip: If you can only get a partial view behind trim, scan it with your phone to avoid misreading characters from an awkward angle.

Video Guide

Video Tutorial: VIN Locations - Hyundai Tucson (2010-2015) - YouTube

▶ Watch Hyundai Tucson VIN Location Guide

• Clear walkthrough showing the three primary VIN locations on the correct Tucson model: windshield plate, driver door jamb label, and the stamped floor VIN under the seat/carpet flap.

Common Problems & Troubleshooting

• Windshield VIN glare: If sunlight washes out the plate, change your angle or shade the glass with your body before scanning/photographing.
• Under-seat floor VIN is dark + low contrast: Slide the seat fully back, lift the carpet flap, and use a flashlight; wipe dust off the stamping so the characters separate from the metal.
• Door jamb sticker validity: If the certification label is missing, torn, repainted over, or doesn’t match other VIN locations, treat it as a red flag and verify using the stamped VIN.

---

This guide shows you where to find the VIN/chassis number on the Hyundai Tucson I (2005–2007), including the common “inspection” stamp under the seat and other factory VIN points you may need for registration, verification, or parts matching.

Chassis Number Locations

Under front passenger seat (floor/chassis stamp)

• Where to look: Open the front passenger door and look under the front passenger seat. Find the pre-cut carpet flap in the floor covering, then lift the flap to expose the metal cross-member/floor. The VIN is stamped directly into the metal.
• Access: Moderate. It’s low and dark, and the flap can be stiff or hidden by floor mats—use a flashlight and reposition the seat if needed.
• Note: The inspected vehicle is LHD and the stamp is under the front right seat (passenger side). If your Tucson is RHD, this stamp is typically still found on the right-hand seat area, so check the right side first.
• Tip: Because it’s usually in shadow, use the flashlight and OCR to scan it cleanly—you can scan the VIN directly with your phone instead of trying to read faint stamps in the dark.

Windshield / dashboard VIN plate (driver-side lower corner)

• Where to look: Stand outside the vehicle and look through the bottom corner of the windshield on the driver’s side. You should see a VIN plate/tag on the dashboard near the glass.
• Access: Easy. No tools—just clean the glass if needed.
• Note: This is a standard factory VIN display location on most vehicles.
• Tip: If glare or reflections make it hard to read, capture it instantly with the VIN scanner so you don’t transpose characters (like 8/B or 5/S).

Driver door jamb / B-pillar VIN label

• Where to look: Open the driver’s door and check the door jamb/B-pillar area for the manufacturer sticker (often includes VIN and weight info).
• Access: Easy. Wipe dust off the label to read it.
• Note: Labels can be missing or repainted over on used vehicles—always cross-check with the stamped chassis VIN.
• Tip: If the print is faded, use the free VIN reader to pull the characters clearly without guessing.

Engine Number Location (for matching engine identity)

Engine block stamp (near transmission junction)

• Where to look: Open the hood. Standing at the front of the car, look down to the right side of the engine (as you face it), near where the engine meets the transmission. The engine number is stamped on a machined flat boss deep in the bay, partially hidden by hoses/piping. In the video, a bolt with a red marking is used as a reference point—the stamp is adjacent to that area.
• Access: High difficulty. The stamp is deep, greasy/dirty, and the viewing angle is awkward—expect to use a strong light and possibly clean the surface.
• Note: This is an engine number, not the body VIN—use it to verify engine identity against paperwork where required.
• Tip: Because the characters are often oily and hard to focus on, clean the boss lightly and then use High Contrast scanning to decipher the stamp instead of trying to write it down in a cramped position.

Video Guide

Video Tutorial: How to Find the Hyundai Tucson Chassis and Engine Number

▶ Watch Hyundai Tucson VIN Location Guide

• Real-world walkthrough showing the under-seat carpet flap for the chassis VIN and the deep engine-block stamp reference point (including the marked bolt).

Common Problems & Troubleshooting

• Can’t find the under-seat VIN: Floor mats and the carpet edge can hide the pre-cut flap—slide the seat back and pry/lift the flap carefully, then use a flashlight.
• Engine stamp unreadable: Grease and grime fill the stamped characters—scrub with a rag and mild degreaser, then re-check with strong light (a phone camera may struggle to focus).
• Sticker VIN vs stamped VIN mismatch: Door-jamb labels and dash plates can be replaced—always verify the stamped chassis VIN matches the paperwork before buying or registering.

---