Where is the VIN in the Mercedes-Benz GLE?

This guide covers the VIN (chassis number) locations on the Mercedes-Benz GLE (C167) produced between 2020–2021, including the quick exterior VIN, the door jamb label, and the hidden stamped VIN under the seat-area carpet.

Chassis Number Locations

B-Pillar (Door Jamb) Label

• Where to look: On the driver’s side B-pillar (center pillar) with the door open—look for a black certification label with white text that includes the VIN (often plus paint code and weight ratings).
• Access: Easy access—just open the driver’s door; no tools needed.
• Note: Works the same for LHD/RHD—this is the driver’s door opening area for your market.
• Tip: Because it’s high-contrast and often includes a machine-readable code, use the free VIN reader to scan it cleanly in one shot with your phone at /en/scan-vin/.

Windshield Lower Corner

• Where to look: At the bottom corner of the windshield on the driver’s side, visible from outside the vehicle.
• Access: Generally easy, but glare, tint, or a dirty windshield can hide characters.
• Note: Best checked from outside in daylight—adjust your viewing angle to cut reflections.
• Tip: If reflections are fighting you, capture it instantly instead of hand-typing by using /en/scan-vin/ and letting the camera/OCR grab the VIN before the glare wins.

Floor VIN (Stamped Under Front Right Seat / Carpet Flap)

• Where to look: A stamped chassis VIN in the floor, under the front right seat area (commonly the passenger side on LHD vehicles).
• Access: Moderate effort:
  1. Slide the front right seat all the way back.
  2. Find the carpet flap/cutout in the floor area under the front edge of the seat.
  3. Lift the carpet flap to expose the VIN stamped into the metal.
• Note: The stamping is consistently on the right-hand side of the vehicle (as seen in the direction of travel). On LHD cars that’s usually the passenger side—if you don’t find it there, check the opposite footwell for your market/trim.
• Tip: It’s usually dark and the stamping can be low-contrast—turn on flashlight and scan instead of squinting by using /en/scan-vin/ (Flashlight + OCR helps a lot here).

MBUX Digital Display (VIN in Vehicle Info)

• Where to look: On the MBUX infotainment screen, inside the vehicle “Settings/Info” menus under vehicle data where the VIN is shown.
• Access: Easy if the vehicle has power (battery connected/ignition on). No trim removal needed.
• Note: Screen glare can affect readability—shade the display with your hand if needed.
• Tip: If you’re copying from the screen to paperwork, scan the VIN from the display to avoid transcription errors using /en/scan-vin/.

Video Guide

Video Tutorial: MERCEDES BENZ GLE300D (W1N167) VIN LOCATION / CHASSIS NUMBER LOCATION

▶ Watch Mercedes-Benz GLE VIN Location Guide

• Walk-around showing the exterior VIN/label and the exact process for lifting the carpet flap to reveal the stamped floor VIN.

Video Tutorial: Mercedes GLE 2021 VIN number location

▶ Watch Mercedes-Benz GLE VIN Location Guide

• Quick MBUX navigation demo to display the VIN on the infotainment screen.

Common Problems & Troubleshooting

• Windshield VIN is hard to read: Glare, condensation, or dirt can blur characters—change your viewing angle and wipe the glass before scanning.
• Stamped floor VIN looks “blank”: The stamping sits in a dark footwell and can be low-contrast—slide the seat fully, lift the carpet flap completely, and use a strong light.
• Sticker vs. stamped VIN: Door jamb labels can be damaged or replaced—always cross-check the label VIN against the stamped floor VIN and the windshield VIN when buying or inspecting.

---

This guide shows the VIN (chassis number) locations on the Mercedes-Benz GLE (V167) produced between 2019–2021, including the quickest “open-the-door” label and the hidden stamped VIN under the carpet.

Chassis Number Locations

B-Pillar Certification Label

• Where to look: Open the front passenger door (LHD) and look at the B-pillar in the door aperture. The VIN is printed on a black sticker with white text, typically below the door latch striker area.
• Access: Easy—just open the door fully. Watch for glare from sunlight or camera flash on the glossy label.
• Note: On RHD cars the same type of label is on the front passenger side B-pillar (left side of the vehicle), but for most LHD GLEs it’s on the right-side B-pillar (front passenger door opening).
• Tip: If reflections wash out the characters, scan it directly with your phone at a slight angle so the camera grabs the VIN without transcription mistakes.

Floor / Chassis Stamp (Under Front Seat Carpet Flap)

• Where to look: Check the right-side front floor area under the front seat. There’s usually a pre-cut carpet flap—lift it to reveal the VIN stamped into the metal floor/cross-member.
• Access: Moderate. The carpet flap can be stiff, and the area is dark under the seat, so you’ll be working at an awkward angle while holding the flap up.
• Note: The stamp is consistently on the right side of the vehicle. On LHD models that’s commonly under the front passenger seat; on RHD models it may end up under the driver seat—but it’s still the right-side floor location.
• Tip: Because it’s shadowed under the seat, use ScanVin’s Flashlight + OCR scanning to capture the stamped VIN without fighting the lighting and angles.

Windshield VIN (Visible VIN Plate)

• Where to look: Look through the windshield at the lower corner, where the VIN is visible behind the glass (commonly on the driver-side lower corner depending on market).
• Access: Very easy—viewable from outside the vehicle—but windshield glare can make it hard to read.
• Note: This is a common “visible VIN” location on this generation even when you don’t want to open doors or lift carpets.
• Tip: If the glass is reflecting sky/overhead lights, capture it quickly with the VIN scanner so you don’t misread characters like 8/B or 5/S.

Video Guide

Video Tutorial: Mercedes GLE 2021 VIN number location - YouTube

▶ Watch Mercedes-Benz GLE VIN Location Guide

• Point-of-view walkaround of an LHD GLE: shows the passenger-side B-pillar label, then lifts the carpet flap under the right-side front seat area to reveal the stamped chassis VIN.

Common Problems & Troubleshooting

• B-pillar label glare: If the sticker looks “blank” on camera, change your angle and avoid direct flash—glossy black labels reflect hard.
• Stamped VIN under-seat is too dark / awkward: Use a flashlight and clean the metal lightly if dusty; hold the carpet flap up while you scan.
• Sticker vs. stamp mismatch: If the door label looks tampered with or missing, always confirm against the stamped floor VIN before buying or registering.

---

This guide shows you where to find the VIN (chassis number) on the Mercedes-Benz GLE (C292) produced between 2016–2016, including easy “at-a-glance” tags and the hidden stamped chassis locations.

Chassis Number Locations

B-Pillar Certification Label

• Where to look: Open the driver’s door and look on the lower section of the driver-side B-pillar/door shut for a black sticker with white text.
• Access: Generally easy to access and read, but the label can be damaged from wear in the door jamb; glossy surfaces can also create glare.
• Note: On LHD vehicles this is on the left (driver) side; on RHD it’s on the right (driver) side.
• Tip: If reflections wash out the letters, use your phone to scan it directly with ScanVin.app so you don’t have to re-type a partially-glared VIN.

Front Right Footwell (A-Pillar/Floor) VIN Stamp

• Where to look: In the front right footwell, find a small plastic access door on the lower A-pillar trim near the floor carpet; pry it open to reveal the VIN stamped into the metal behind it.
• Access: High difficulty—tight opening, recessed stamp, awkward camera angle, and very poor lighting.
• Note: For LHD vehicles this is commonly on the passenger side (front right), but check the driver side footwell if not found.
• Tip: Turn on flash and keep the camera square to the stamping—then capture it with the phone scanner in ScanVin.app to avoid writing it down while crouched in the footwell.

Under the Front Right Seat (Floor) VIN Stamp

• Where to look: Slide the front right seat back and lift the pre-cut carpet flap to expose the VIN stamped on the metal floor cross-member underneath.
• Access: Moderate to hard—requires moving the seat and lifting carpet; it’s dark under there, so bring extra light.
• Note: This is on the front right side; on LHD vehicles that’s typically the passenger side, but verify both sides if needed.
• Tip: Because it’s shadowy under the seat, use Flashlight + OCR and scan the stamp with ScanVin.app instead of trying to read it off-angle.

Windshield (Dashboard VIN Plate)

• Where to look: Check the VIN plate at the bottom corner of the windshield, viewed from outside through the glass.
• Access: Easy to see when clean, but glare/reflections and wiper position can block the view.
• Note: On LHD vehicles it’s typically on the left (driver) side lower windshield area.
• Tip: If sunlight reflects off the glass, move your body to shade the plate and use the VIN reader on ScanVin.app to grab it instantly without transcription mistakes.

Video Guide

Video Tutorial: Mercedes ML350 VIN number locations on models W164 2005 ...

▶ Watch Mercedes-Benz GLE VIN Location Guide

• A technician demonstrates the door-jamb label plus the hidden stamped VIN locations under carpet/trim, including the footwell access-door area.

Common Problems & Troubleshooting

• Too dark to read (footwell / under-seat stamps): Use a flashlight/phone flash and shoot straight-on; angled photos blur the stamped characters.
• Can’t find the access flap/door: Feel along the lower A-pillar trim and carpet edge for a small plastic cover; gently pry—don’t force and crack the trim.
• Sticker issues: Door-jamb labels can fade, peel, or get damaged—always confirm the VIN matches a stamped body VIN before buying.

---

This guide covers the VIN number locations on the Mercedes-Benz GLE (W166) produced between 2016–2016, including the quick-to-scan labels and the hidden stamped chassis number.

Chassis Number Locations

Front Right Footwell / Lower A-Pillar (Chassis Stamped VIN – Primary)

• Where to look: Check the front right side lower A-pillar / door-sill edge by the footwell. There’s typically a rectangular cut-out in the carpet/trim and a small plastic cover you need to unclip/slide to reveal the stamped metal VIN recessed in the structure.
• Access: Moderate difficulty. You’ll be working low down near the trim; the VIN is recessed and hard to read without direct light.
• Note: The source vehicle shown is RHD, where this stamp is accessed from the front right (driver) footwell. For LHD (US/EU), start on the front right footwell (commonly passenger side), but check the driver-side footwell if you don’t find it on the right.
• Tip: Because the stamp sits in a deep recess with heavy shadows, use the flashlight + OCR and scan it directly with your phone camera instead of trying to read it at an awkward angle.

Lower B-Pillar / Door Jamb (VIN Sticker)

• Where to look: Open the front door and inspect the lower B-pillar (door jamb) area. You’re looking for a black sticker with white text listing the VIN and vehicle data.
• Access: Easy. No tools needed; usually clean and high-contrast.
• Note: Depending on market/region, the sticker may be on the driver-side or passenger-side B-pillar—check both if needed.
• Tip: This is the fastest one to capture—use the free VIN reader to scan the sticker cleanly and avoid mixing up similar characters (8/B, 0/O).

Windshield VIN Plate (Visible VIN)

• Where to look: From outside the vehicle, look through the bottom corner of the windshield for the visible VIN plate.
• Access: Easy, but reflections are common (sunlight, dash glare, tinted glass).
• Note: Best viewed at an angle; sometimes easier from the passenger-side corner depending on light.
• Tip: If glare/reflections make it hard to read, capture it instantly with the scanner so you don’t misread characters or transpose digits.

Under the Front Right Seat (Floor/Chassis Stamped VIN – Often Not Used on W166)

• Where to look: Slide the front right seat all the way forward and lift the carpet flap/cut-out on the floor to check for a stamped VIN.
• Access: High physical effort (moving the seat fully), usually dark underneath, and you may find the flap area empty on W166.
• Note: The video specifically explains this “under-seat VIN” is a common reference for older models, and the demonstrated W166-style vehicle shows the flap without a VIN—the primary stamp is in the front right footwell/lower A-pillar instead.
• Tip: If you’re going to check it anyway, it’s cramped and poorly lit—scan with flashlight + OCR so you’re not trying to hand-copy a code from under a seat.

Video Guide

Video Tutorial: Mercedes Benz ML350 - Resetting Service (ML350 2012 - 2015) and (GLE350 2016 - 2018) W166

▶ Watch Mercedes-Benz GLE VIN Location Guide

• A technician shows the windshield VIN, the door jamb sticker, and the hidden footwell/A-pillar chassis stamp, including why the “under-seat” flap is often not the correct VIN location on W166.

Common Problems & Troubleshooting

• Footwell stamp is “missing”: It’s usually behind a small plastic cover in the lower A-pillar/footwell trim—pry/unclip it carefully and hit it with a flashlight to see the recessed stamping.
• Windshield VIN is unreadable: Glare and reflections are normal—change your viewing angle, shade the area with your hand, or scan it instead of squinting through the glass.
• Sticker doesn’t prove identity by itself: Door-jamb stickers can be replaced—always cross-check the sticker VIN against the chassis-stamped VIN before buying.

---