Where is the VIN number in Peugeot Partner III (2017-2017)?

This guide covers where to find the VIN (chassis number) on the Peugeot Partner III (2017-2017).

Chassis Number Locations

Engine Bay (Bulkhead / Firewall under the windshield cowl)

• Where to look: Open the hood and look at the firewall/bulkhead (the metal panel between engine bay and cabin), just below the windshield cowl. The VIN is stamped into the metal, roughly centered (often slightly offset depending on market).
• Access: You must lift/unclip the felt/fabric sound insulation flap on the bulkhead. It’s tucked under the plastic cowl edge and held with clips/fasteners. Use a flashlight—this area sits in shadow and can be dirty with leaves/debris.
• Note: Location is essentially the same on LHD and RHD; the stamp is generally central on the bulkhead area.
• Tip: Because it’s dark and recessed, use the flashlight and let OCR do the reading—you can scan it directly with your phone instead of trying to squint at the stamping.

Engine Bay (Inner Wing / Strut Tower area – sticker or alternate stamping on some variants)

• Where to look: Check the front inner wing / strut tower area (near the coolant reservoir on many setups). Some vehicles have a VIN sticker, and some variants show an additional stamped VIN along the inner wing rail.
• Access: Easy to reach, but the sticker is often faded/dirty, and stamped numbers can be painted over, reducing contrast. Wipe with a rag and use angled light to make the stamping “shadow” pop.
• Note: Layout can vary by market and model twin (Partner/Berlingo share platform), so treat this as a secondary confirmation location.
• Tip: If the print is faded or the stamp is body-colored, try using the high-contrast VIN scanner to pull the characters out without guesswork.

Windshield (Dashboard VIN plate)

• Where to look: Look through the lower corner of the windshield at the dashboard VIN plate (commonly driver-side for LHD, passenger-side for RHD).
• Access: No tools—just view it from outside. The main issue is glare/reflections on the glass.
• Note: If you can’t see it clearly in sunlight, shade the glass with your hand/body or move the car slightly.
• Tip: To beat reflections and transcription mistakes, capture it instantly with the VIN reader instead of manually typing the string.

Door Pillar / B-Pillar manufacturer label (VIN sticker)

• Where to look: Open a front door and inspect the B-pillar area for the manufacturer label (VIN + tire pressures). Side can vary by market.
• Access: Very easy—just open the door and clean the label if it’s dusty.
• Note: This is a label, not a metal stamping—use it for reference, but always cross-check with the stamped chassis VIN when possible.
• Tip: If the label is scratched or dirty, scan the sticker with your phone to avoid misreading worn characters.

Video Guide

Video Tutorial: Peugeot Partner Teepee (2014) Chassis Vin Number Location pr/str

▶ Watch Peugeot Partner VIN Location Guide

• Shows the exact bulkhead/firewall VIN position and the key step: lifting the felt insulation flap to reveal the stamped chassis number.

Common Problems & Troubleshooting

• “I can’t see any VIN in the engine bay.” You’re probably looking at the bulkhead without lifting the felt sound-deadening flap—unclip it and use a flashlight.
• “The stamping is there but unreadable.” Dirt, leaves, and low light under the cowl are common—clean the area and use angled light to highlight the stamped relief.
• Sticker warning: Inner-wing and door-pillar VIN stickers can fade, peel, or be replaced—for identity checks, the stamped metal VIN is the one you want to match.

---