Where is the VIN in the Toyota Camry?

This guide shows where to locate the VIN (chassis number) on the Toyota Camry IX (XV80) [2020-2020]. If one VIN is hard to read, use the secondary locations below to cross-check before buying parts, registering the car, or verifying vehicle identity.

Chassis Number Locations

1) Floor stamp (under front passenger seat)

• Where to look: Slide the front passenger seat all the way back and look at the floor cross-member. The VIN is stamped directly into the metal under a rectangular carpet flap or plastic cover.
• Access: Moderate. You’ll need to move the seat, then lift the flap / remove the cover. Lighting is usually poor in the footwell shadows.
• Note: This spot swaps sides on RHD cars. On LHD vehicles it’s commonly under the right/front passenger seat; on RHD vehicles it’s under the left/front passenger seat (still the passenger side). If you don’t find it, check the opposite front footwell floor.
• Tip: Because it’s dark and awkward to hold the carpet up, use the phone flash and OCR to scan it directly with ScanVin.app instead of trying to read the stamp at an angle.

2) B-pillar certification label (driver door jamb)

• Where to look: Open the driver door and inspect the driver-side B-pillar (door jamb). You’ll find a black certification sticker with white text that includes the VIN.
• Access: Easy. Good lighting with the door open; no tools needed. Watch for stickers that are peeling or faded.
• Note: On RHD vehicles, the “driver side” is the opposite side of the car—so check the B-pillar on the side with the steering wheel.
• Tip: This label is high-contrast, so it’s perfect to use the free VIN reader and avoid transcription mistakes.

3) VIN plate at lower windshield (driver side)

• Where to look: From outside the car, look through the windshield at the bottom corner on the driver side, where the dashboard meets the glass. The VIN plate is visible through the windshield (often with a QR code nearby).
• Access: Easy, but reflections are common. Clean the glass if needed.
• Note: Reflections/glare are the main issue—especially in direct sun.
• Tip: If glare makes characters “wash out,” capture it instantly with your phone from a slight angle rather than trying to type it in.

4) Engine bay stamp (firewall / cowl area)

• Where to look: With the hood open, inspect the firewall/cowl area near the back of the engine bay (close to the wiper/cowl region). The VIN/chassis number can be stamped into the metal.
• Access: Low to moderate. This area can be partially hidden by plastic cowl trim or weather stripping, and dirt can fill the stamped characters.
• Note: If you can’t see it, change your viewing angle and use a light—don’t confuse nearby casting numbers with the VIN.
• Tip: If the stamp is faint or dirty, scan it using high-contrast AI mode so you don’t misread similar characters (8/B, 5/S, 0/O).

Video Guide

Video Tutorial: TOYOTA CAMRY chassis and Engine Number Location

▶ Watch Toyota Camry VIN Location Guide

• Shows the windshield VIN, B-pillar label, and the floor VIN under the seat, plus an engine number close-up.

Video Tutorial: TOYOTA CAMRY HYBRID CHASSIS NUMBER & 2AR ENGINE ...

▶ Watch Toyota Camry VIN Location Guide

• A professional inspection-style walkthrough (RHD) showing the firewall stamp and lifting the carpet to access the floor VIN.

Common Problems & Troubleshooting

• Carpet flap won’t sit open / too dark to read: slide the seat fully back, pry the flap up carefully, and use a flashlight to avoid misreading stamped characters.
• Engine bay stamp is grimy or partially hidden: scrub lightly with a rag/brush and adjust viewing angle; stamped numbers can “disappear” if dirt fills the grooves.
• Door-jamb sticker missing or faded: labels can peel or be replaced—always cross-check with the floor stamp (harder to tamper with) and the windshield plate.

---

This guide covers the VIN (Vehicle Identification Number) and chassis number locations for the Toyota Camry VIII (XV70) produced between 2018–2020, with instructions written for LHD (left-hand drive) vehicles.

Chassis Number Locations

Dashboard VIN Plate (Windshield)

• Where to look: From outside the car, stand at the lower left (driver’s-side) corner of the windshield and look down at the dash—there’s a VIN plate under the glass with a QR code next to the characters.
• Access: Low difficulty. No tools needed, but glare and dirty glass can block the view.
• Note: On LHD cars, this is on the left side of the windshield.
• Tip: If reflections are making characters hard to read, capture it instantly with your phone using the glare-friendly approach—use the camera and scan the VIN directly instead of typing it out.

Driver’s Door Jamb Label (B-Pillar Certification Sticker)

• Where to look: Open the driver’s door and locate the black certification label on the lower section of the driver’s-side B-pillar (door jamb). It shows the VIN, plus paint/weight info.
• Access: Low difficulty. Very accessible with excellent contrast (white text on black sticker).
• Note: On LHD cars, this label is on the left side (driver’s side).
• Tip: This is one of the easiest surfaces to read—use your camera to use the free VIN reader and avoid misreading characters like 8/B or 0/O.

Floor VIN Stamp (Under Front Passenger Seat / Carpet Flap)

• Where to look: Open the front passenger door and look under the front passenger seat. Find the pre-cut flap in the carpet and slide/lift the flap to expose the VIN stamped into the chassis/floor pan cross-member.
• Access: Medium difficulty. You’ll be crouched outside the car, working in a dark area under the seat; you may need to move the seat for better access.
• Note: This is commonly on the front right floor area for LHD vehicles (passenger side), but check the driver-side front footwell if you don’t find it.
• Tip: Because it’s shadowy and awkward to hold steady, turn on light and let the camera do the work—use Flashlight + OCR to scan it with your phone without trying to write it down under the seat.

Engine Block Number (Engine Number)

• Where to look: In the engine bay, locate the engine block stamping on a vertical flat machined surface on the metal casting, facing forward/slightly right (from the driver’s perspective), near the alternator and accessory belts. The code is stamped into the metal.
• Access: High difficulty. It sits deep in the bay near hoses/belts and is often greasy or grimy—a flashlight and a rag/brush help.
• Note: This is the engine number, not the windshield VIN plate—use it for engine verification during inspections.
• Tip: If the stamping is dirty or low-contrast, wipe it and use High Contrast AI Mode—you can capture the engine number cleanly instead of guessing characters from an awkward angle.

Video Guide

Video Tutorial: TOYOTA CAMRY chassis and Engine Number Location

▶ Watch Toyota Camry VIN Location Guide

• Walkthrough of the XV70 Camry showing the engine number, windshield VIN, driver B-pillar label, and the floor/chassis stamp under the passenger seat carpet flap.

Common Problems & Troubleshooting

• Windshield VIN glare: If the sun hits the glass, the VIN plate washes out—change viewing angle, shade the area, and clean the outside of the windshield.
• Under-seat floor VIN is hard to access: The carpet flap can stick and the area is dark—slide the seat, lift the flap carefully, and use a flashlight to avoid missing the stamped digits.
• Sticker vs. stamped VIN mismatch: Door-jamb labels can be replaced—always cross-check with the windshield VIN and the stamped floor/chassis VIN when verifying a vehicle.

---

This guide shows where to find the VIN (chassis number) on the Toyota Camry VII (XV50) produced between 2012 and 2014, including the easiest scan points and the “hidden” stamped locations used for verification.

Chassis Number Locations

Under Front Passenger Seat (Floor Pan Stamp)

• Where to look: Under the front passenger seat, on the floor pan/cross-member. Slide the seat all the way back and lift the pre-cut carpet flap to reveal the VIN stamped directly into the metal.
• Access: Tight and very dark—plan on kneeling in the doorway. You may need to pry the carpet flap up with your fingers and wipe dust off the stamping.
• Note: This is under the front passenger seat (so the side of the car changes between LHD and RHD markets—don’t rely on “left/right,” rely on “passenger seat”).
• Tip: Because it’s dark and the characters can be hard to read at an angle, use the flashlight and let OCR do the work—scan the VIN directly with your phone** instead of writing it down under the seat.**

B-Pillar / Door Jamb Certification Label (Sticker)

• Where to look: Open a front door and inspect the B-pillar (the post between the front and rear doors). Look for a black sticker with white text listing manufacturing data and the VIN.
• Access: Very easy—standing height, no tools. Just clean the label gently if it’s dusty.
• Note: Label position can vary by region (driver-side or passenger-side B-pillar), but it’s always on a door jamb/pillar area.
• Tip: If the label is faded or you don’t want transcription errors, use the high-contrast camera capture—use the free VIN reader** to grab the whole code cleanly in one shot.**

Windshield (Dashboard VIN Plate)

• Where to look: From outside the car, check the lower corner of the windshield on the driver’s side. The VIN is visible on a small plate/tag at the base of the dashboard.
• Access: Easy, but positioning matters—move around until the plate is readable through the glass.
• Note: If you can’t see it, check for glare, a dirty windshield, or wiper/debris blocking the corner.
• Tip: Reflections are the main problem here—capture it quickly with your phone using ScanVin.app so you don’t misread characters through glass glare.

Engine Bay (Cowling / Firewall Stamp)

• Where to look: Open the hood and look at the center area of the firewall/cowling panel, near the wiper linkage zone—just below the windshield edge and rubber weather strip. The VIN is stamped into the metal panel (some trims may look slightly different around the plastics).
• Access: Often shadowed by the hood and surrounding components. You’ll usually need a flashlight and a rag to wipe dust/grime off the stamping.
• Note: On some trims (including Hybrid), hoses/wiring and plastic cowling pieces can partially block the view—take your time and look along the metal seam under the windshield edge.
• Tip: If the stamping is dirty and low-contrast, wipe it and use AI contrast to read it—scan it directly** instead of guessing worn characters in the engine bay.**

Video Guide

Video Tutorial: TOYOTA CAMRY chassis and Engine Number Location

▶ Watch Toyota Camry VIN Location Guide

• Walk-around showing common VIN points (windshield, door jamb label, floor stamp) and also where the engine number is stamped.

Video Tutorial: TOYOTA CAMRY HYBRID CHASSIS NUMBER & 2AR ENGINE ...

▶ Watch Toyota Camry VIN Location Guide

• Clear demo on a Camry Hybrid showing the engine-bay/cowl VIN area and the floor VIN under the passenger-seat carpet flap (RHD orientation shown).

Common Problems & Troubleshooting

• Can’t see the floor VIN under the seat: Slide the seat fully back, lift the carpet flap, and use a flashlight; the stamping is often upside down/awkward angle, so wipe it clean before reading.
• Engine-bay VIN looks “missing”: It’s commonly shadowed and grimy near the cowl—aim light from the side and scrub lightly with a rag to bring the characters out.
• Door jamb sticker doesn’t match stamped VIN: Stickers can be replaced or faked—for verification, trust the metal-stamped VIN locations (floor/firewall) and investigate any mismatch before buying.

---