Where is the VIN in the Volkswagen Caddy?

This guide covers where to find the VIN (chassis number) on the Volkswagen Caddy V ([2019-2019]).

Chassis Number Locations

B-Pillar Sticker

• Where to look: Open the front passenger door (LHD: right side). Look low on the B-pillar/door frame for the manufacturer’s data sticker that includes the VIN.
• Access: Very easy—no tools. The only issue is wear, peeling, or damage to the sticker over time.
• Note: The videos are filmed on RHD cars, so the “passenger side” shown there is the left side. On LHD Caddy models, this sticker is typically on the right side.
• Tip: If the label is scuffed or the print is faint, use the free VIN reader to scan it cleanly with /en/scan-vin/ instead of guessing characters.

Lower Windshield (Dashboard VIN Plate)

• Where to look: Stand outside the vehicle and look through the bottom corner of the windshield on the passenger side (LHD: typically right side). The VIN is displayed on a plate visible through the glass.
• Access: No tools, but it can be hard to read due to glare/reflections and dirt/wiper marks.
• Note: RHD vs LHD can mirror which lower corner you check first—if you don’t see it on one corner, check the other.
• Tip: If reflections are washing it out, capture it instantly with your phone using /en/scan-vin/ so you don’t mistype the VIN.

Rear Cargo Area (Inner Quarter Panel) – Stamped VIN

• Where to look: Open the rear barn doors/tailgate. Inside the cargo area, find the rectangular inspection/access panel in the side wall trim near the rear light area. Remove the cover to reveal the VIN stamped vertically into the metal.
• Access: Tool-less cover removal, but it’s commonly dark inside the cavity with heavy shadows. Paint thickness can also hide parts of the stamping.
• Note: The videos show this on RHD vehicles. On LHD vehicles, the side trim location may be mirrored—check the opposite cargo side panel if you don’t find the access cover on the first side.
• Tip: Because it’s deep and shadowy, scan it with Flashlight + OCR using /en/scan-vin/ instead of struggling to read the vertical stamp.

Engine Bay (Strut Tower / Bulkhead Stamp)

• Where to look: Open the bonnet. Look on the right-hand side area near the strut tower/bulkhead (rain tray area) for a VIN stamped into the bodywork.
• Access: Usually reachable, but often dirty/dusty, and the view can be tight around hoses, lines, and plastic trims.
• Note: Don’t assume “driver side” here—use fixed reference points (right-hand side of the vehicle in the direction of travel) and search the bulkhead/strut tower area carefully.
• Tip: If the stamp is dusty or low-contrast, use High Contrast AI Mode to pick out faint characters by scanning with /en/scan-vin/.

Video Guide

Video Tutorial: 2018 vw caddy vin and engine number locations

▶ Watch Volkswagen Caddy V VIN Location Guide

• Comprehensive walkthrough showing the windshield VIN, B-pillar sticker, engine bay view, and additional VIN/number locations.

Video Tutorial: 2018 Volkswagen Caddy Stamped Vin Number Location

▶ Watch Volkswagen Caddy V VIN Location Guide

• Walkaround focused on the hidden rear cargo-area stamped VIN behind the side inspection cover.

Video Tutorial: VW Caddy (2016) Chassis Vin Location pr/bt-jk

▶ Watch Volkswagen Caddy V VIN Location Guide

• Clear close-up of the rear cargo-side inspection hole showing why extra light helps when reading the chassis stamp.

Common Problems & Troubleshooting

• Too dark to read (rear cargo stamp): Remove the access cover fully and use a strong light; the VIN is often vertical and shadowed inside the cavity.
• Dirty or obstructed engine-bay stamp: Wipe the area with a rag and reposition hoses/covers gently for a clear viewing angle (don’t force plastic clips).
• Sticker vs stamped VIN mismatch: Door-jamb stickers can be replaced or damaged—for verification, cross-check the sticker VIN against the windshield plate and a stamped body VIN.

---

This guide covers where to find the VIN (chassis number) on the Volkswagen Caddy IV produced between 2016 and 2019, including the common “hidden” stamped VIN in the rear cargo area.

Chassis Number Locations

Rear Cargo Area (Right Wheel Arch / Jack Storage Compartment)

• Where to look: Open the rear cargo doors/tailgate. On the right-hand inner wall of the cargo area (D-pillar area), locate the jack storage compartment. Remove the plastic cover panel, then look upwards/inwards on the structural metal frame above the jack—the VIN is stamped into the body, sometimes vertically.
• Access: Poor lighting and recessed position. You’ll need to remove the trim cover to see the stamp, and it can be awkward to read if it’s vertical.
• Note: This is the right side of the vehicle (direction of travel). “Driver/passenger side” wording changes between LHD/RHD, but the VIN stamp stays on the same physical side.
• Tip: Because it’s a dark cavity and the stamp can be hard to orient, use the flashlight and OCR to scan it directly with your phone via ScanVin.app VIN scanner instead of trying to read it sideways.

Vehicle Identification Label (A-Pillar / Door Jamb Sticker)

• Where to look: Open the front passenger door and check the A-pillar/door jamb (the vertical body frame at the front of the door opening). The label typically lists the VIN, plus paint/engine codes and option info.
• Access: Usually easy access with good lighting if the door is fully open. The main issue is age-related wear (fading/peeling).
• Note: If you’re comparing paperwork to the vehicle quickly, this sticker is often the fastest reference—but it’s not as tamper-resistant as a stamped VIN.
• Tip: If the sticker text is faded, take a quick close-up and let the camera OCR capture the VIN accurately using the free VIN reader so you don’t misread worn characters.

Firewall / Rain Tray (Engine Bay)

• Where to look: Open the hood. At the base of the windshield, locate the plastic rain tray/scuttle area. Lift the rubber weather strip/seal running across the back of the engine bay and check the metal firewall lip—the VIN is stamped there but can be partially hidden by trim.
• Access: Commonly obstructed by the rubber seal and plastic cowling. This area traps leaves and grime, so you may need to wipe it clean before the stamp becomes readable. You’ll often be holding the seal up with one hand.
• Note: This is a secondary stamped location—use it to cross-check the rear cargo stamp.
• Tip: If dirt and partial obstruction make characters hard to see, wipe the area, then use high-contrast scanning to pick out faint stamp marks with ScanVin.app while you hold the seal up.

Video Guide

Video Tutorial: 2018 Volkswagen Caddy Stamped Vin Number Location

▶ Watch Volkswagen Caddy VIN Location Guide

• Quick walkaround showing the rear cargo VIN location behind the right-side jack cover on a Caddy IV van.

Video Tutorial: Volkswagen vw Caddy vin number location

▶ Watch Volkswagen Caddy VIN Location Guide

• Close-up footage inside the rear jack compartment showing the stamped VIN on the inner body structure.

Common Problems & Troubleshooting

• VIN stamp is “there but unreadable” in the rear compartment: The cavity is deep and unlit—remove the cover fully, change your viewing angle, and use a strong light (or scan with OCR).
• Engine-bay stamp looks incomplete: The rubber seal/plastic scuttle often covers the lower part of the characters—lift the seal and scrub away grime/leaves before attempting to read.
• Sticker doesn’t match or is missing: Door-jamb stickers can fade, peel, or be replaced—always verify against a stamped VIN before buying or registering.

---

This guide covers the VIN (chassis number) locations on the Volkswagen Caddy III [2011-2011] so you can quickly match the vehicle to its documents or decode its factory specs.

Chassis Number Locations

Engine Bay (Firewall / Rain Tray Stamping)

• Where to look: Open the hood and look at the center of the firewall/rain tray area, just below the windshield. The VIN is stamped into the metal chassis in the middle.
• Access: Lift the rubber weather strip that runs across the back of the engine bay; you may need to lift the plastic cowling slightly. Expect dirt/grime packed in the recess—wipe and scrub the stamping so the characters stand out.
• Note: This location is central, so it’s the same for LHD and RHD vehicles.
• Tip: If the stamping is shallow or filled with grime, use ScanVin’s High Contrast AI Mode to scan it directly with your phone instead of guessing worn characters.

Door Jamb / B-Pillar VIN Sticker (Spec Label)

• Where to look: Check the passenger-side pillar area (commonly the B-pillar between the front door and sliding door, or the A-pillar door jamb). You’re looking for a black/white specification sticker that includes the VIN plus weights/paint codes.
• Access: Usually fully visible with the door open—on work vans it may be worn, torn, painted over, or missing.
• Note: On LHD Caddy models this is typically on the right/passenger side; on RHD it’s typically on the left/passenger side.
• Tip: This label is high-contrast, so it’s ideal to use the free VIN reader to capture it cleanly without transcription mistakes.

Rear Cargo Area (Jack/Tool Compartment Behind Side Panel)

• Where to look: In the rear cargo area, remove the plastic access cover panel on the side wall (commonly the left side). Inside the jack storage cavity, the VIN sticker is usually mounted vertically on the metal pillar next to the jack/tools.
• Access: You must pop off/remove the cover and then aim into a tight cavity. It’s very dark, and the sticker text is small. On some vans, aftermarket lining/shelving can block access.
• Note: This is generally shown on the left side regardless of steering position.
• Tip: Because it’s a dark cavity, turn on your phone light and scan it with Flashlight + OCR instead of trying to read tiny print at an angle.

Windshield (Dash VIN Plate/Etching)

• Where to look: Look through the windshield at the bottom corner of the dashboard (commonly driver-side on many vehicles). You should see the VIN through the glass if equipped.
• Access: No tools—just view from outside—but reflections and glare can hide characters.
• Note: If it’s not visible or the glass is heavily tinted, use the chassis stamp and pillar label above.
• Tip: If glare/reflection makes it hard to read, capture it instantly with your phone to avoid mixing up characters like 8/B or 5/S.

Video Guide

Video Tutorial: Volkswagen Caddy chassis and engine number location

▶ Watch Volkswagen Caddy VIN Location Guide

• Shows lifting the rubber seal at the firewall/rain tray to reveal the stamped chassis VIN, and also points out the door-jamb spec sticker.

Video Tutorial: Volkswagen vw Caddy vin number location

▶ Watch Volkswagen Caddy VIN Location Guide

• Demonstrates removing the rear side access panel and finding the VIN label inside the jack/tool storage cavity.

Common Problems & Troubleshooting

• Stamped VIN hard to read (engine bay): Dirt packs under the rubber strip—spray, wipe, and scrub the stamping, then re-check with a flashlight.
• Rear VIN sticker unreadable: The jack compartment is dark and cramped—remove the cover fully and light the area before reading/scanning.
• Sticker vs. stamp mismatch: A door-jamb sticker can be replaced or damaged—when verifying identity, prioritize the stamped chassis VIN and ensure it matches paperwork.

---