Where is the VIN in the Mercedes-Benz E-Class?

This guide covers where to find the VIN (Vehicle Identification Number) on the Mercedes-Benz Klasa E (W214) produced between 2021–2021, including the most common body/chassis stamping points and the quickest places to scan.

Chassis Number Locations

Front right floor (under front seat / carpet flap)

• Where to look: Slide the front passenger seat back (typical for LHD), then locate the pre-cut slit/flap in the carpet in the front footwell floor area. Lift the flap to reveal the VIN stamped into the metal cross-member under the seat area.
• Access: Usually dark and tight on space; you may need your phone flashlight. If the car has aftermarket floor mats, remove them. If the battery is dead and the seat won’t move, access can be blocked.
• Note: This stamped floor VIN is commonly on the right side of the car (often the passenger side for LHD). If you don’t find it there, check the opposite front footwell.
• Tip: Because it’s shadowy under the seat, use the flash + OCR to scan the VIN directly with your phone instead of squinting and writing it down in a cramped position.

B-pillar door-jamb sticker (right side on many LHD cars)

• Where to look: Open the front passenger door (common for LHD) and look on the B-pillar/door jamb for a black label with white text. It typically lists the VIN, paint code, and weight info.
• Access: Easiest location to reach, but the label can be peeled, faded, painted over, or missing after bodywork.
• Note: Label side can vary by market (LHD vs RHD), so check the opposite side if you don’t see it.
• Tip: The high-contrast label is perfect for a quick capture—use the free VIN reader to avoid transcription mistakes and instantly copy/share the number.

Windshield VIN plate (lower dashboard, driver-side corner)

• Where to look: From outside the car, look through the lower corner of the windshield at the dashboard area (typically driver-side).
• Access: Fast to check, but glare/reflections can make it hard to read and photograph cleanly.
• Note: Clear any papers/tickets from the dash so the plate is visible.
• Tip: If reflections fight your camera focus, capture it with your phone in one clean shot and let OCR pull the characters without you guessing.

Engine bay stamped VIN (right inner wing area)

• Where to look: Open the hood and inspect the right-side inner fender/inner wing support area. The VIN is typically stamped vertically into the metal near structural members (often close to the suspension tower/coolant reservoir zone).
• Access: Often dirty/greasy, sometimes partially blocked by hoses/wiring; you may need to wipe/scrub the metal for visibility.
• Note: This is a good cross-check location when verifying the car’s identity against documents/labels.
• Tip: After wiping grime off, scan it in high-contrast mode to help decode faint or dusty stampings on vertical metal surfaces.

Video Guide

Video Tutorial: Where is the VIN for the Mercedes-Benz E-Class W213 ... - YouTube

▶ Watch Mercedes-Benz Klasa E VIN Location Guide

• Shows the door-jamb sticker and the under-carpet floor stamping under the front seat area.

Video Tutorial: MERCEDES BENZ E350e (W213) 2017 CHASSIS NUMBER LOCATION & M274 ENGINE NUMBER LOCATION.

▶ Watch Mercedes-Benz Klasa E VIN Location Guide

• Walks through the B-pillar label, the floor VIN under the seat flap, and the engine bay stamping.

Video Tutorial: Mercedes E Class Coupe Vin Number Location How to find

▶ Watch Mercedes-Benz Klasa E VIN Location Guide

• Close-up of the interior process: sliding the seat and lifting the carpet flap to reveal the stamped VIN.

Common Problems & Troubleshooting

• Can’t access the floor VIN: If the electric seat won’t move (dead battery), you may not reach the carpet flap—start with the B-pillar label and windshield VIN first.
• Engine bay VIN unreadable: Road dust/grease can hide the stamping—spray mild cleaner, wipe, then re-check with a light at an angle.
• Sticker vs stamped VIN mismatch: Door stickers can be replaced after repairs—when buying, always compare documents + B-pillar label + stamped body VIN (floor/engine bay) for consistency.

---

This guide covers the VIN (chassis number) locations on the Mercedes-Benz E-Class W213, produced between 2016–2021, including the common “quick check” VIN and the harder-to-reach stamped chassis VIN used for verification.

Chassis Number Locations

Under the front seat (floor cross-member, stamped VIN)

• Where to look: In the front footwell floor area under the front seat, on a metal cross-member. Access is through a pre-cut flap in the carpet/floor mat; the VIN is stamped into painted metal.
• Access: Slide the seat back, lift the carpet flap, and aim light across the stamp to make the characters pop. Expect poor lighting and low contrast because the metal is body-colored/painted.
• Note: The video shows an RHD car with the floor VIN on the right side. For LHD cars, start by checking the front footwell floor (commonly on the passenger side for LHD vehicles, but check the driver side footwell if not found).
• Tip: Because this area is shadowed by the carpet and seat rails, use the Flashlight + OCR to scan it directly with your phone instead of guessing characters while crouched in the cabin.

B-pillar certification label (VIN sticker)

• Where to look: Open the front door and check the lower B-pillar for a black sticker label with white VIN text (often also shows paint code and weight limits).
• Access: No tools—just open the door and read it; lighting is usually good, but the lower pillar can be shadowed in a garage.
• Note: The report indicates passenger-side B-pillar for LHD and driver-side B-pillar for RHD (market rules vary, so if you don’t see it, check the other side).
• Tip: This label is high-contrast and scans cleanly—use the camera OCR to use the free VIN reader and avoid mistyping a 17-digit code.

Windshield / dashboard VIN (quick-view)

• Where to look: From outside the car, look at the bottom corner of the windshield where the VIN is visible through the glass.
• Access: No tools; best viewed in daylight, but reflections can wash it out.
• Note: This is the fastest “walk-up” check and should match the stamped floor VIN.
• Tip: If glare/reflections make it hard to read, move your angle slightly and capture it with your phone so you don’t transpose similar characters (0/O, 1/I).

Engine bay (engine number / stamped ID on engine block)

• Where to look: In the engine bay, the video demonstrates the engine number stamped on a machined flat surface on the engine block (deep in the bay near hoses/wiring).
• Access: Tight access and awkward angles; you’ll likely need strong light and patience to line up your camera.
• Note: This is typically the engine serial/number, not the 17-digit VIN—don’t confuse the two during inspection paperwork.
• Tip: Because it’s buried and hard to photograph cleanly, use zoom/focus and scan it with your phone to avoid copying errors while leaning over the fender.

Video Guide

Video Tutorial: MERCEDES BENZ E350e (W213) 2017 CHASSIS NUMBER LOCATION & M274 ENGINE NUMBER LOCATION

▶ Watch Mercedes-Benz Klasa E VIN Location Guide

• Shows the hidden floor stamped VIN under the carpet flap (RHD example) and demonstrates where the engine number is stamped on the M274 engine.

Common Problems & Troubleshooting

• Can’t read the floor VIN: The stamp is painted and low-contrast; rake a flashlight across it (side-lighting) and wipe dust off the metal before scanning.
• Carpet flap won’t lift cleanly: Slide the seat further back, then pry/lift the pre-cut flap carefully—don’t tear the carpet backing.
• Sticker VIN doesn’t prove identity: The B-pillar label can be replaced or peeled—always cross-check it against the stamped floor VIN (and windshield VIN where fitted).

---

This guide shows you where to find the VIN (vehicle identification number) on the Mercedes-Benz Klasa E (W211) produced between 2002–2009, including the most reliable hidden chassis stamp and the quicker “check-first” labels.

Chassis Number Locations

Front floor (under seat)

• Where to look: Front right floor, directly under the front right seat (typically the passenger side in LHD cars). There’s a small rectangular cut-out in the carpet covered by a plastic flap/vent—the VIN is stamped into the metal underneath.
• Access: Low difficulty. Slide the front right seat all the way back, locate the rectangular plastic cover, then lift the flap to expose the stamped VIN. No tools usually needed, but bring a light.
• Note: On RHD models, this stamped floor VIN still stays on the right side of the vehicle (it does not “swap sides” with the steering wheel).
• Tip: Because this area is shadowy, use your phone to scan it with flashlight + OCR—try the free VIN scanner to capture the characters cleanly without guessing.

B-pillar label (door jamb)

• Where to look: Right B-pillar / door jamb area (open the front right door). You’re looking for a black or silver manufacturer sticker listing the VIN plus paint/weight info.
• Access: Easy. Open the door and read the label—no tools.
• Note: Use this as a quick check, but always compare it to the stamped VIN if you’re verifying identity.
• Tip: If the sticker text is small or worn, scan the VIN with your phone so you don’t mistype a character (common with 8/B, 5/S).

Windshield (dashboard)

• Where to look: Lower driver-side corner of the windshield, viewed from outside the car, where the VIN is visible through the glass on the dash.
• Access: Easy, but visibility varies due to reflections and the angle.
• Note: Best checked in shade or with the glass clean.
• Tip: To beat glare/reflections, capture it instantly with the VIN reader instead of trying to read it at an awkward angle.

Engine bay (firewall / bulkhead or radiator support)

• Where to look: With the hood open, check the firewall/bulkhead area (often center or slightly right), and also look for a metal plate on the front radiator support/crossmember.
• Access: High difficulty. It can be obscured by covers, hoses, or grime; you may need to wipe surfaces to see a stamp/plate clearly.
• Note: Treat engine-bay markings as a secondary verification point.
• Tip: If the stamp is dirty or faint, clean it lightly and use High Contrast scanning to pull the characters out of low-contrast metal.

Video Guide

Video Tutorial: Mercedes E Class Coupe Vin Number Location How to find - YouTube

▶ Watch Mercedes-Benz Klasa E VIN Location Guide

• Shows how to slide the seat back and lift the carpet flap to reveal the hidden floor VIN stamp.

Common Problems & Troubleshooting

• You can’t find the flap: Slide the seat fully back and feel along the carpet crossmember for the rectangular plastic cover—it’s easy to miss in low light.
• VIN is hard to read on the metal stamp: Use a flashlight and change viewing angle; if needed, wipe dust off the metal so the stamping edges show.
• Sticker VIN vs stamped VIN mismatch: Door-jamb stickers can be replaced—always confirm the stamped chassis VIN matches your documents before purchase/registration.