Where is the VIN number in Volkswagen Caddy (Caddy III [2011-2011])?

This guide covers the VIN (chassis number) locations on the Volkswagen Caddy III [2011-2011] so you can quickly match the vehicle to its documents or decode its factory specs.

Chassis Number Locations

Engine Bay (Firewall / Rain Tray Stamping)

• Where to look: Open the hood and look at the center of the firewall/rain tray area, just below the windshield. The VIN is stamped into the metal chassis in the middle.
• Access: Lift the rubber weather strip that runs across the back of the engine bay; you may need to lift the plastic cowling slightly. Expect dirt/grime packed in the recess—wipe and scrub the stamping so the characters stand out.
• Note: This location is central, so it’s the same for LHD and RHD vehicles.
• Tip: If the stamping is shallow or filled with grime, use ScanVin’s High Contrast AI Mode to scan it directly with your phone instead of guessing worn characters.

Door Jamb / B-Pillar VIN Sticker (Spec Label)

• Where to look: Check the passenger-side pillar area (commonly the B-pillar between the front door and sliding door, or the A-pillar door jamb). You’re looking for a black/white specification sticker that includes the VIN plus weights/paint codes.
• Access: Usually fully visible with the door open—on work vans it may be worn, torn, painted over, or missing.
• Note: On LHD Caddy models this is typically on the right/passenger side; on RHD it’s typically on the left/passenger side.
• Tip: This label is high-contrast, so it’s ideal to use the free VIN reader to capture it cleanly without transcription mistakes.

Rear Cargo Area (Jack/Tool Compartment Behind Side Panel)

• Where to look: In the rear cargo area, remove the plastic access cover panel on the side wall (commonly the left side). Inside the jack storage cavity, the VIN sticker is usually mounted vertically on the metal pillar next to the jack/tools.
• Access: You must pop off/remove the cover and then aim into a tight cavity. It’s very dark, and the sticker text is small. On some vans, aftermarket lining/shelving can block access.
• Note: This is generally shown on the left side regardless of steering position.
• Tip: Because it’s a dark cavity, turn on your phone light and scan it with Flashlight + OCR instead of trying to read tiny print at an angle.

Windshield (Dash VIN Plate/Etching)

• Where to look: Look through the windshield at the bottom corner of the dashboard (commonly driver-side on many vehicles). You should see the VIN through the glass if equipped.
• Access: No tools—just view from outside—but reflections and glare can hide characters.
• Note: If it’s not visible or the glass is heavily tinted, use the chassis stamp and pillar label above.
• Tip: If glare/reflection makes it hard to read, capture it instantly with your phone to avoid mixing up characters like 8/B or 5/S.

Video Guide

Video Tutorial: Volkswagen Caddy chassis and engine number location

▶ Watch Volkswagen Caddy VIN Location Guide

• Shows lifting the rubber seal at the firewall/rain tray to reveal the stamped chassis VIN, and also points out the door-jamb spec sticker.

Video Tutorial: Volkswagen vw Caddy vin number location

▶ Watch Volkswagen Caddy VIN Location Guide

• Demonstrates removing the rear side access panel and finding the VIN label inside the jack/tool storage cavity.

Common Problems & Troubleshooting

• Stamped VIN hard to read (engine bay): Dirt packs under the rubber strip—spray, wipe, and scrub the stamping, then re-check with a flashlight.
• Rear VIN sticker unreadable: The jack compartment is dark and cramped—remove the cover fully and light the area before reading/scanning.
• Sticker vs. stamp mismatch: A door-jamb sticker can be replaced or damaged—when verifying identity, prioritize the stamped chassis VIN and ensure it matches paperwork.

---