Where is the VIN number in Toyota Yaris iA (2017-2017)?

This guide covers the VIN (chassis number) locations for the Toyota Yaris iA produced between 2017 and 2017, including the quick-to-check spots and the hidden stamped chassis locations.

Chassis Number Locations

1) Floor stamping (under right-hand front seat / commonly passenger seat on LHD)

• Where to look: Slide the right-hand front seat all the way back. Look on the floor for a pre-cut flap in the carpet/floor mat area. Lift the flap to reveal the VIN stamped directly into the metal chassis cross-member.
• Access: You’ll need to move the seat for room, then lift the carpet flap. Expect poor lighting, heavy shadows, and dirt/debris—wipe the stamping clean before reading.
• Note: For LHD (US/Canada) cars, the right-hand front seat is typically the front passenger seat. If you don’t find it there, check the opposite front seat area as well.
• Tip: Because it’s dark under the seat and the stamp can be dusty, use your phone light and scan it directly with ScanVin.app to let OCR grab the characters without you squinting under the seat.

2) Driver’s side dashboard (visible through windshield)

• Where to look: Stand outside the car and look through the windshield at the top-left of the dashboard (driver’s side on LHD cars). You’ll see the VIN on a small plate.
• Access: Easiest access—no tools. The main issue is windshield glare/reflections (sunlight, streetlights, tinted glass).
• Note: This is the most “standard” public VIN display location on most US/EU vehicles.
• Tip: If reflections make the characters hard to read, capture it instantly with the VIN scanner so you don’t mistype a letter/number (common mix-ups: 8/B, 5/S, 0/O).

3) Certification label (driver’s door jamb / B-pillar)

• Where to look: Open the driver’s door and check the driver-side door jamb/B-pillar area for the VIN sticker/certification label.
• Access: Very easy—just open the door and aim a light if needed. Sticker condition can vary with age (scuffs, peeling, fading).
• Note: This label is great for quick verification, but it’s not the same as the stamped chassis VIN.
• Tip: If the label is worn or low-contrast, use the free VIN reader to improve capture accuracy without manually copying faded print.

4) Engine bay stamping (firewall / cowl area)

• Where to look: In the engine compartment, look deep toward the firewall, slightly toward the center-right (passenger-side area). The stamping is on a flat metal surface/bar below the cowl/air intake area and can be partially blocked by hoses/intake components.
• Access: Hard to reach and hard to see. You’ll be working at an awkward angle with limited line-of-sight; expect grime. A strong light and cleaning rag help.
• Note: This is a secondary verification spot when you need to compare multiple VIN locations.
• Tip: Since it’s deep, dark, and often dirty, clean the area and scan with high-contrast OCR using ScanVin.app so you don’t have to write it down while leaning over the engine bay.

Common Problems & Troubleshooting

• Can’t find the floor VIN: The carpet flap may be hidden under floor mats or packed with debris—pull the mat back, slide the seat fully rearward, lift the pre-cut flap, and wipe the metal stamp clean.
• VIN is there but unreadable: Dirt, shadows, and awkward angles (especially under-seat and engine bay) can hide characters—use a strong flashlight and clean the surface before scanning/reading.
• Door-jamb sticker doesn’t match or looks tampered: Stickers can be replaced—always cross-check the windshield VIN and the stamped chassis VIN (floor) when verifying a vehicle.

---